What Actually Happens During a Session
Whether you're booking a single club or a full bag assessment, every appointment runs through the same four-stage process, and every trim gets its own logged ticket.
Baseline Read
We frequency-test your current clubs uncut on the bench, along with a short conversation about your misses, goals, and typical playing conditions.
Live Demo Testing
We work through relevant heads and pre-trimmed test shafts from our wall, recording every swing so we can compare options against your own baseline numbers rather than a chart alone.
Chart-Referenced Cut
Once a shaft and trim length are chosen, we cut it on the bench, square and deburr the tip, and re-read the frequency board to confirm the shift landed where planned.
Build & Verify
Clubs are built in-house and checked on our swing-weight scale before you pick them up, usually within a week, cut ticket attached.
What the Ticket Actually Shows You
Every trim gets logged on a numbered ticket before and after the cut, so you're not taking our word for what changed. Rather than being told a shaft "should" feel stiffer, you watch the frequency reading move on the board as the tip section comes off.
- Baseline frequency logged before any cut is made
- Trim length chosen against the manufacturer's published chart
- A printed cut ticket handed over at pickup, not filed away
- No obligation to purchase — the ticket is yours either way
See the Process for Yourself
Book a session and watch the frequency board move as we trim.